vitaltotal.blogg.se

Atmel usb installer
Atmel usb installer











atmel usb installer

These 3 observation are in direct conflict with the printed Studio V7 error message, which is miss leading as to fault. If you have this problem, double check VGT like I did. VCC measured by voltmeter showed 4.97 V close enough to 5.00V ! obviously the squid was connected properly.Ī double check of the squid (unchanged for years) showed pin 4 VTG was connected to VCC as required for Mega2560. The ICE showed it had power(center red LED on) and the target had power (left Green LED on). Studio gave message "Failed to launch program", "Error: Target power not connected.

atmel usb installer

I disconnected the 10 pin female IDC with squid and moved it to the new small ICE adapter board, and pointed Studio/project/tools to it.īoth MK II and ICE are to used with the JTAG interface for advanced debug over an ISP interface. I bought a second new smaller AT-ATMEL-ICE. I have a Studio V7 with a ICE Mk II and mega2560 with a squid cable running fine for years on win 10.













Atmel usb installer